EZ Loader TA102BS Trailer Parts Guide — Hubs, Brakes, Bunks & Hardware
Find the right parts for your EZ Loader TA102BS trailer—without guesswork.
The TA102BS is a wider-frame EZ Loader tandem axle bunk trailer equipped with leaf spring suspension. These trailers are commonly used for larger fiberglass boats, center consoles, and heavier hulls where additional width and stability are needed.
This guide helps you identify the most common replacement parts and where to start.
What Trailer This Is
- “TA” = Tandem Axle
- “102” = Approximate overall trailer width (outside of tire to outside of tire)
- “B” = Bunk system
- “S” = Leaf spring suspension
Material Note: Most EZ Loader aluminum trailers include an “A” in the model. If there’s no “A,” it’s typically galvanized—but we always confirm before matching parts.
These trailers are commonly found in capacity ranges from approximately 4,000 lb up to 10,000 lb, depending on axle configuration, frame design, and intended use.
Important: Not all TA102BS trailers are identical. Axles, hubs, brakes, and bunk setups can vary.
Common Replacement Parts
Common replacement parts include:
- Bunk boards (wood or composite)
- Carpet or poly bunk covering
- Upright or horizontal bunk brackets
- Top hat brackets, L-style brackets, strap-style (“pork chop”) brackets, and mounting hardware
Fitment matters: Wider trailers require proper bunk spacing, height, and alignment for correct hull support.
Hubs & Bearings
EZ Loader TA102BS trailers may use either oil bath hubs or grease-packed hubs, depending on the year, axle setup, and any upgrades over time.
Correct fitment depends on:
- Spindle size
- Bolt pattern (typically 5-lug or 6-lug)
- Axle rating
Start here:
Not sure which you have? Give us your hub or axle measurements—we’ll match it correctly.
Brakes
TA102BS trailers may be equipped with disc brakes or drum brakes, depending on configuration and upgrades.
Common replacement items include:
- Brake pads
- Rotors or drums
- Calipers
- Brake lines
Start here:
Important: Brake components must match your hub size, axle rating, and mounting configuration.
Bunks & Brackets
The bunk system is critical on wider trailers to maintain proper hull support.
Common replacement parts include:
- Bunk boards and coverings
- Upright support brackets
- Top hat brackets and mounting hardware
Start here:
Fitment matters: Proper spacing and height adjustment are critical for safe loading and transport.
Hardware & Mounting Components
Spring axle trailers rely heavily on properly installed hardware components.
- U-bolts (frame mounting)
- Leaf spring hardware (shackles, bushings, equalizers)
- Hex bolts and lag screws
- Lock nuts and washers
Start here:
Not Sure? Call Us First
Trailer parts are not one-size-fits-all.
The fastest way to get the right parts is to confirm your setup before ordering.
📞 Call 843-784-5797
We’ll help you match the correct parts based on your trailer.
No texting — just real answers from real people.
What to Have Ready When You Call
- Trailer model (TA102BS or similar)
- VIN (if available)
- Axle or hub measurements
- Photos of your current setup (very helpful)
Photos are often the fastest way for us to confirm the correct parts.
Compare Similar Models
Running torsion axles? See the TA102BT Parts Guide.
Need a narrower frame? See the TA96BS Parts Guide.