EZ Loader TA102BT Trailer Parts Guide — Hubs, Brakes, Bunks & Hardware
Find the right parts for your EZ Loader TA102BT trailer—without guesswork.
The TA102BT is a wider-frame EZ Loader tandem axle bunk trailer with torsion axle suspension. These trailers are commonly used for larger center consoles, offshore boats, and heavier fiberglass hulls where increased width and stability are required.
This guide helps you identify the most common replacement parts and where to start.
What Trailer This Is
- “TA” = Tandem Axle
- “102” = Approximate overall trailer width (outside of tire to outside of tire)
- “B” = Bunk system
- “T” = Torsion axle suspension
Material Note: Most EZ Loader aluminum trailers include an “A” in the model. If there’s no “A,” it’s typically galvanized—but we always confirm before matching parts.
These trailers are typically found in higher capacity ranges, often from approximately 4,000 lb up to 17,500+ lb, depending on configuration.
Important: Not all TA102BT trailers are identical. Axles, hubs, brakes, and bunk configurations can vary.
Common Replacement Parts
Common replacement parts include:
- Bunk boards (wood or composite)
- Carpet or poly bunk covering
- Upright or horizontal bunk brackets
- Top hat brackets, L-style brackets, strap-style (“pork chop”) brackets, and mounting hardware
Fitment matters: Wider trailers require correct bunk spacing, height, and alignment to properly support the hull.
Hubs & Bearings
EZ Loader TA102BT trailers may use either oil bath hubs or grease-packed hubs, depending on the axle setup, weight rating, and any upgrades over time.
Correct fitment depends on:
- Spindle size
- Bolt pattern (typically 5-lug or 6-lug, sometimes 8-lug on heavier setups)
- Axle rating
Start here:
Not sure which you have? Give us your hub or axle measurements—we’ll match it correctly.
Brakes
TA102BT trailers are more commonly equipped with disc brakes, especially on higher-capacity setups.
Common replacement items include:
- Brake pads
- Rotors
- Calipers
- Brake lines
Start here:
Important: Brake components must match hub size, axle rating, and mounting configuration.
Bunks & Brackets
The bunk system is critical on wider trailers to maintain proper hull support across a larger footprint.
Common replacement parts include:
- Bunk boards and coverings
- Upright support brackets
- Top hat brackets and mounting hardware
Start here:
Fitment matters: Wider bunk spacing and correct height adjustment are critical for stability and safe loading.
Hardware & Mounting Components
Heavier trailers place more demand on hardware components.
- U-bolts (frame mounting)
- High-strength hex bolts
- Lock nuts and washers
- Bracket mounting hardware
Start here:
Not Sure? Call Us First
Trailer parts are not one-size-fits-all.
The fastest way to get the right parts is to confirm your setup before ordering.
📞 Call 843-784-5797
We’ll help you match the correct parts based on your trailer.
No texting — just real answers from real people.
What to Have Ready When You Call
- Trailer model (TA102BT or similar)
- VIN (if available)
- Axle or hub measurements
- Photos of your current setup (very helpful)
Photos are often the fastest way for us to confirm the correct parts.
Compare Similar Models
Need a narrower frame? See the TA96BT Parts Guide.
Running a spring axle version? See the TA102BS Parts Guide (coming soon).